 |
 |
| The AC Servo Drive
has simple and well-balanced structure: special AC servo motors are directly
connected to the right and the left ends of the eccentric shaft. With the streamlined
operation, the mechanism has realized high hit rate and optimum stroke according
to the sheet thickness. |
 |
 |
| This is a new mechanism
to collect and store in a capacitor the energy generated while brake is applied
to the ram and enables reusing the stored energy for accelerating the ram. |
 |
|
 |
 |
Check die status |
|
|
 |
Push up the ejector pipe to push up
the die onto the turret's top surface. |
|
 |
Extract the die
(no tool required) |
|
| P&F mechanism offers
die positioning in increments of 0.01mm as well as a variety of processing capabilities
(utilizing lance die etc.). It has achieves high-precision positioning, constant
pass line and 25mm of feed clearance. These features collectively enable high-form
height fabrication. |
|
 |
|
25mm feed
clearance
|
Hold the material by the punch
to secure the forming accuracy.
|
Push-up the die chip
to complete the form.
The pass-line is always same as reguler die.
|
|
|
|
|
Prevent slug pull during high speed punching.
Power Vacuum slug pull system (Slug Pick-Up prevention for small diameter die)
Strong downward airstreams will be generated inside the die to extract slug.
This system enables shorter penetration (where punch enters only 1mm into die) |
| |
 |
| Negative pressure
is generated and makes slugs go down. |
|
|
|
 Laser
Processing-equivalent finish for special & R shapes. Specialized nibbling
tool enables nibbling at pitches less than sheet thickness. As a result, filling
after processing is no longer necessary. Even hit count is increased, process
time can be significantly reduced owing to Ultra High-speed processing. |
|
Automatically completes minimum flange bending.
This process method enables downward bending where burrs are internally oriented.
It also enables to perform minimum flange bending and bending of R too small
for
Pressbrake processing. |
 |
| Electrical Galvanized
t=0.8mm |
|
 |
 |
|
|
|
|
|
|
