 |
 |
|
| With an RF discharge excitation
laser oscillator, the consumption rate of laser gas goes down to 1/3, and electrodes
do not wear while the optical system can enjoy a much longer service life. These
help reduce the running cost. |
 |
|
 Ultra high-speed and high accuracy
processing is available with a lighter driving unit and an AC servo motor combined
with a state-of-the-art digital servo controller. |
|
| (Optional) |
 Nitrogen extracted from the
air is used as assist gas. It works best on bonderized steel sheet. Effective
to reduce assist gas cost. |
|
| (Optional) |
 A high-quality method of cutting
to prevent stainless steel from discoloring and oxidation at the cut. |
|
| (Optional) |
 Machine's
eye to provide accurate processing for the combination with punching machine.
Origin compensation.
Measuring the pitch between holes. Automatic focal point compensation. Measuring
hole size. |
|
|
 With a working table 820mm high,
works may be readily loaded and unloaded, improving workability remarkably. |
|
|
 By combination with HS-2000,
a collision between work clamps and processing head can be eliminated. The dead
zone area is reduced to one-fifth of the conventional model, providing a higher
yield. |
|
| (Optional) |
 The
gap between work and cutting head may be non-contact maintained constant. An
NC special port for "Z" axis
allows high-speed follow-up. |
|
|
 A Y axis full-width work chute
enables even large-scale works to be taken out without use of a micro joint. |
|
 The cutting roller and urethane
roller which rotate synchronously with the work minimizes that it gets scratched
on its rear side. Accordingly, stainless steel and aluminum surface treated can
be finished smooth. |
 |
 |
 |
